PCBpro - Send Files Sample Page
Index : PCB Order Process : Send PCB Files Sample Page

*** This is a sample page only. Please do not try and upload files. Send your files to: files@pcbpro.com ***

Ready to send your files to PCBpro?
 Yes, Upload now => **SAMPLE**
(have you reveiwed our file checklist below?)
No, send your files later to:
 files@pcbpro.com 		When sending your files, make sure the subject line for your e-mail is:
Files for PCBpro order# (your order# here)

*** This is a sample page only. Please do not try and upload files. Send your files to: files@pcbpro.com ***

For your order, we need the following files sent in a .zip file to files@pcbpro.com:
(click here for sample readme to use as reference)
Drill file In Excellon format. This file should contain finished tool sizes, and X & Y coordinates.
  Some software also produces a tool list. Send this if you have it. It may be needed.
Gerber files for: File format-Gerber 274X (embedded apertures), or 274D with aperature list
Layer 1 Top copper ( veiwed from top looking down through to the bottom, pads .017" larger than holes.
Layer 2 -7 The inner layer (signal layers) should have pads .018" larger than finished hole size.
  For ground and power layers the clearances around through holes should be .025"min. larger than finished tool size.
  To avoid copper being exposed at the boards routed edge, the copper needs to be .025" away from board outline.
Layer 8 Bottom copper, copper features within .010" of board outline on top or bottom may be cut by router.
Top Soldermask Mask relief .008" larger than pad sizes.
Bottom Soldermask Soldermask areas with less than .005" remaining may have to be removed for processing.
Top Silkscreen A .007" line is the smallest that can print through the silkscreen.
Bottom Silkscreen Correct reading from the bottom side.
Board outline This can be a separate layer, or added to any of the above layers.
Drawing layer This may be needed if your software outputs the board outline, or layer stack up in it.
  The drawing notes when in conflict with your order form, or our stated tolerances will not be referenced.

*** This is a sample page only. Please do not try and upload files. Send your files to: files@pcbpro.com ***

Questions?
PCBpro disclaimer | sample readme| pcb glossary | pcb capabilities

Copyright 2007 PCBpro-Sunstone Circuits. All Rights Reserved.  


Printed circuit board links for your reference:
PCB quote links: pcb quote | pcb help | circuit board tutorial | pcb site map | pcb request for quote
Circuit board resource pcb links: pcb design tips | pcb glossary | circuit board manufacturing capabilities | pcb library
PCBpro company links: contact a pcb specialist | about pcb pro | pcb testimonials | privacy & security